selftests/bpf: Test packet range of pointers sharing an idgrafted

Add tests where two packet pointers share an id and tightening one
pointer's umax from its var_off would put it less than their constant
distance from the other's umax: with an index & 0x38 capped at 50, the
base pointer keeps umax 50, so the pointer 8 bytes further on must keep
umax 58, even though its known bits allow at most 56.

These refused a valid program or accepted an out-of-bounds access before
the fix:

- check the advanced copy, load through the base: valid, was refused;
- check the base, load the byte at base + 1 through a copy advanced by
  8: was accepted;
- check base + 4, load 4 bytes at base + 2 through base + 8: reads two
  bytes past the checked range, was accepted;
- the same as the second with data_meta pointers checked against data:
  was accepted.

These pass with and without the fix and cover nearby paths:

- subtract an unknown scalar from a checked pointer and load below it
  (the range is kept across a new id);
- reach a load through two paths whose checks cover 8 and 7 bytes after
  the loaded pointer; the second path must not be pruned by the first;
- spill a copy of a pointer, check the pointer, fill the copy and load
  one byte past the checked range: the load is refused, and the copy
  has the range of the check.

Signed-off-by: Alexei Starovoitov <ast@kernel.org>
Link: https://lore.kernel.org/bpf/20261001145255.855630-2-alexei.starovoitov@gmail.com
Signed-off-by: Kumar Kartikeya Dwivedi <memxor@gmail.com>

1 files changed, 62 insertions, 0 deletions

diff --git a/drivers/usb/isp1760/Kconfig b/drivers/usb/isp1760/Kconfig
new file mode 100644
index 000000000..e19178f3c
--- /dev/null
+++ b/drivers/usb/isp1760/Kconfig
@@ -0,0 +1,62 @@
+# SPDX-License-Identifier: GPL-2.0
+
+config USB_ISP1760
+	tristate "NXP ISP 1760/1761/1763 support"
+	depends on USB || USB_GADGET
+	select REGMAP_MMIO
+	help
+	  Say Y or M here if your system as an ISP1760/1763 USB host controller
+	  or an ISP1761 USB dual-role controller.
+
+	  This driver does not support isochronous transfers or OTG.
+	  This USB controller is usually attached to a non-DMA-Master
+	  capable bus. NXP's eval kit brings this chip on PCI card
+	  where the chip itself is behind a PLB to simulate such
+	  a bus.
+
+	  To compile this driver as a module, choose M here: the
+	  module will be called isp1760.
+
+config USB_ISP1760_HCD
+	bool
+
+config USB_ISP1761_UDC
+	bool
+
+if USB_ISP1760
+
+choice
+	prompt "ISP1760 Mode Selection"
+	default USB_ISP1760_DUAL_ROLE if (USB && USB_GADGET)
+	default USB_ISP1760_HOST_ROLE if (USB && !USB_GADGET)
+	default USB_ISP1760_GADGET_ROLE if (!USB && USB_GADGET)
+
+config USB_ISP1760_HOST_ROLE
+	bool "Host only mode"
+	depends on USB=y || USB=USB_ISP1760
+	select USB_ISP1760_HCD
+	help
+	  Select this if you want to use the ISP1760 in host mode only. The
+	  gadget function will be disabled.
+
+config USB_ISP1760_GADGET_ROLE
+	bool "Gadget only mode"
+	depends on USB_GADGET=y || USB_GADGET=USB_ISP1760
+	select USB_ISP1761_UDC
+	help
+	  Select this if you want to use the ISP1760 in peripheral mode only.
+	  The host function will be disabled.
+
+config USB_ISP1760_DUAL_ROLE
+	bool "Dual Role mode"
+	depends on USB=y || USB=USB_ISP1760
+	depends on USB_GADGET=y || USB_GADGET=USB_ISP1760
+	select USB_ISP1760_HCD
+	select USB_ISP1761_UDC
+	help
+	  Select this if you want to use the ISP1760 in both host and
+	  peripheral modes.
+
+endchoice
+
+endif