From 33a154a96e71a34a1bcca9f40da343dbbf7b38b4 Mon Sep 17 00:00:00 2001 From: Alexei Starovoitov Date: Thu, 1 Oct 2026 14:52:55 +0000 Subject: selftests/bpf: Test packet range of pointers sharing an id Add tests where two packet pointers share an id and tightening one pointer's umax from its var_off would put it less than their constant distance from the other's umax: with an index & 0x38 capped at 50, the base pointer keeps umax 50, so the pointer 8 bytes further on must keep umax 58, even though its known bits allow at most 56. These refused a valid program or accepted an out-of-bounds access before the fix: - check the advanced copy, load through the base: valid, was refused; - check the base, load the byte at base + 1 through a copy advanced by 8: was accepted; - check base + 4, load 4 bytes at base + 2 through base + 8: reads two bytes past the checked range, was accepted; - the same as the second with data_meta pointers checked against data: was accepted. These pass with and without the fix and cover nearby paths: - subtract an unknown scalar from a checked pointer and load below it (the range is kept across a new id); - reach a load through two paths whose checks cover 8 and 7 bytes after the loaded pointer; the second path must not be pruned by the first; - spill a copy of a pointer, check the pointer, fill the copy and load one byte past the checked range: the load is refused, and the copy has the range of the check. Signed-off-by: Alexei Starovoitov Link: https://lore.kernel.org/bpf/20261001145255.855630-2-alexei.starovoitov@gmail.com Signed-off-by: Kumar Kartikeya Dwivedi --- drivers/usb/isp1760/Kconfig | 62 +++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 62 insertions(+) create mode 100644 drivers/usb/isp1760/Kconfig (limited to 'drivers/usb/isp1760/Kconfig') diff --git a/drivers/usb/isp1760/Kconfig b/drivers/usb/isp1760/Kconfig new file mode 100644 index 000000000..e19178f3c --- /dev/null +++ b/drivers/usb/isp1760/Kconfig @@ -0,0 +1,62 @@ +# SPDX-License-Identifier: GPL-2.0 + +config USB_ISP1760 + tristate "NXP ISP 1760/1761/1763 support" + depends on USB || USB_GADGET + select REGMAP_MMIO + help + Say Y or M here if your system as an ISP1760/1763 USB host controller + or an ISP1761 USB dual-role controller. + + This driver does not support isochronous transfers or OTG. + This USB controller is usually attached to a non-DMA-Master + capable bus. NXP's eval kit brings this chip on PCI card + where the chip itself is behind a PLB to simulate such + a bus. + + To compile this driver as a module, choose M here: the + module will be called isp1760. + +config USB_ISP1760_HCD + bool + +config USB_ISP1761_UDC + bool + +if USB_ISP1760 + +choice + prompt "ISP1760 Mode Selection" + default USB_ISP1760_DUAL_ROLE if (USB && USB_GADGET) + default USB_ISP1760_HOST_ROLE if (USB && !USB_GADGET) + default USB_ISP1760_GADGET_ROLE if (!USB && USB_GADGET) + +config USB_ISP1760_HOST_ROLE + bool "Host only mode" + depends on USB=y || USB=USB_ISP1760 + select USB_ISP1760_HCD + help + Select this if you want to use the ISP1760 in host mode only. The + gadget function will be disabled. + +config USB_ISP1760_GADGET_ROLE + bool "Gadget only mode" + depends on USB_GADGET=y || USB_GADGET=USB_ISP1760 + select USB_ISP1761_UDC + help + Select this if you want to use the ISP1760 in peripheral mode only. + The host function will be disabled. + +config USB_ISP1760_DUAL_ROLE + bool "Dual Role mode" + depends on USB=y || USB=USB_ISP1760 + depends on USB_GADGET=y || USB_GADGET=USB_ISP1760 + select USB_ISP1760_HCD + select USB_ISP1761_UDC + help + Select this if you want to use the ISP1760 in both host and + peripheral modes. + +endchoice + +endif -- cgit v1.3.1