arm64/boot: Disable trapping of PMZR_EL0 writes to EL2grafted

__init_el2_fgt2() writes one mask to both HDFGRTR2_EL2 and HDFGWTR2_EL2.
PMZR_EL0 is write-only, so its trap bit, nPMZR_EL0, exists only in
HDFGWTR2_EL2 and is therefore never set: a PMZR_EL0 write from the host
traps to EL2, where the nVHE hypervisor has no handler and BUG()s. The
kernel never writes PMZR_EL0, but kernel.perf_user_access=1 has the PMU
driver set PMUSERENR_EL0.UEN for a task with a user-read event, so a
write from EL0 reaches the trap and takes the host down without a panic
message.

Accumulate the HDFGWTR2_EL2 bits separately, as __init_el2_fgt() already
does for HDFGWTR_EL2, and set nPMZR_EL0 with the other FEAT_PMUv3p9
bits.

Fixes: 858c7bfcb35e1 ("arm64/boot: Enable EL2 requirements for FEAT_PMUv3p9")
Cc: stable@vger.kernel.org
Signed-off-by: Fuad Tabba <fuad.tabba@linux.dev>
Reviewed-by: Anshuman Khandual <anshuman.khandual@arm.com>
Reviewed-by: Oliver Upton <oupton@kernel.org>
Signed-off-by: Will Deacon <will@kernel.org>

1 files changed, 29 insertions, 0 deletions

diff --git a/drivers/usb/image/Kconfig b/drivers/usb/image/Kconfig
new file mode 100644
index 000000000..a65c638e7
--- /dev/null
+++ b/drivers/usb/image/Kconfig
@@ -0,0 +1,29 @@
+# SPDX-License-Identifier: GPL-2.0
+#
+# USB Imaging devices configuration
+#
+comment "USB Imaging devices"
+
+config USB_MDC800
+	tristate "USB Mustek MDC800 Digital Camera support"
+	help
+	  Say Y here if you want to connect this type of still camera to
+	  your computer's USB port. This driver can be used with gphoto 0.4.3
+	  and higher (look at <http://www.gphoto.org/>).
+	  To use it create a device node with "mknod /dev/mustek c 180 32" and
+	  configure it in your software.
+
+	  To compile this driver as a module, choose M here: the
+	  module will be called mdc800.
+
+config USB_MICROTEK
+	tristate "Microtek X6USB scanner support"
+	depends on SCSI
+	help
+	  Say Y here if you want support for the Microtek X6USB and
+	  possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L.
+	  Support for anything but the X6 is experimental.
+	  Please report failures and successes.
+	  The scanner will appear as a scsi generic device to the rest
+	  of the system. Scsi support is required.
+	  This driver can be compiled as a module, called microtek.