From 2bc6b218717b9d08f466f88209251d54bc09b207 Mon Sep 17 00:00:00 2001 From: Fuad Tabba Date: Tue, 22 Sep 2026 19:14:30 +0100 Subject: arm64/boot: Disable trapping of PMZR_EL0 writes to EL2 __init_el2_fgt2() writes one mask to both HDFGRTR2_EL2 and HDFGWTR2_EL2. PMZR_EL0 is write-only, so its trap bit, nPMZR_EL0, exists only in HDFGWTR2_EL2 and is therefore never set: a PMZR_EL0 write from the host traps to EL2, where the nVHE hypervisor has no handler and BUG()s. The kernel never writes PMZR_EL0, but kernel.perf_user_access=1 has the PMU driver set PMUSERENR_EL0.UEN for a task with a user-read event, so a write from EL0 reaches the trap and takes the host down without a panic message. Accumulate the HDFGWTR2_EL2 bits separately, as __init_el2_fgt() already does for HDFGWTR_EL2, and set nPMZR_EL0 with the other FEAT_PMUv3p9 bits. Fixes: 858c7bfcb35e1 ("arm64/boot: Enable EL2 requirements for FEAT_PMUv3p9") Cc: stable@vger.kernel.org Signed-off-by: Fuad Tabba Reviewed-by: Anshuman Khandual Reviewed-by: Oliver Upton Signed-off-by: Will Deacon --- drivers/usb/image/Kconfig | 29 +++++++++++++++++++++++++++++ 1 file changed, 29 insertions(+) create mode 100644 drivers/usb/image/Kconfig (limited to 'drivers/usb/image/Kconfig') diff --git a/drivers/usb/image/Kconfig b/drivers/usb/image/Kconfig new file mode 100644 index 000000000..a65c638e7 --- /dev/null +++ b/drivers/usb/image/Kconfig @@ -0,0 +1,29 @@ +# SPDX-License-Identifier: GPL-2.0 +# +# USB Imaging devices configuration +# +comment "USB Imaging devices" + +config USB_MDC800 + tristate "USB Mustek MDC800 Digital Camera support" + help + Say Y here if you want to connect this type of still camera to + your computer's USB port. This driver can be used with gphoto 0.4.3 + and higher (look at ). + To use it create a device node with "mknod /dev/mustek c 180 32" and + configure it in your software. + + To compile this driver as a module, choose M here: the + module will be called mdc800. + +config USB_MICROTEK + tristate "Microtek X6USB scanner support" + depends on SCSI + help + Say Y here if you want support for the Microtek X6USB and + possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. + Support for anything but the X6 is experimental. + Please report failures and successes. + The scanner will appear as a scsi generic device to the rest + of the system. Scsi support is required. + This driver can be compiled as a module, called microtek. -- cgit v1.3.1