diff options
Diffstat (limited to 'drivers/tty')
| -rw-r--r-- | drivers/tty/serial/serial-tegra.c | 18 |
1 files changed, 16 insertions, 2 deletions
diff --git a/drivers/tty/serial/serial-tegra.c b/drivers/tty/serial/serial-tegra.c index 8004fc00f..b0fc4ae36 100644 --- a/drivers/tty/serial/serial-tegra.c +++ b/drivers/tty/serial/serial-tegra.c @@ -306,11 +306,19 @@ static void tegra_uart_fifo_reset(struct tegra_uart_port *tup, u8 fcr_bits) { unsigned long fcr = tup->fcr_shadow; unsigned int lsr, tmout = 10000; + bool clear_tx = !!(fcr_bits & UART_FCR_CLEAR_XMIT); if (tup->rts_active) set_rts(tup, false); - if (tup->cdata->allow_txfifo_reset_fifo_mode) { + /* + * Leaving FIFO mode below is a workaround for a Tegra30 + * restriction on clearing the Tx FIFO while FIFO mode is + * enabled. It empties both FIFOs, so applying it to an + * Rx-only reset would destroy an in-flight transmission. + * Only take that path when the caller asked for CLEAR_XMIT. + */ + if (tup->cdata->allow_txfifo_reset_fifo_mode || !clear_tx) { fcr |= fcr_bits & (UART_FCR_CLEAR_RCVR | UART_FCR_CLEAR_XMIT); tegra_uart_write(tup, fcr, UART_FCR); } else { @@ -335,9 +343,15 @@ static void tegra_uart_fifo_reset(struct tegra_uart_port *tup, u8 fcr_bits) */ tegra_uart_wait_cycle_time(tup, 32); + /* + * Only wait for the transmitter to drain when the Tx FIFO was + * part of the reset. For an Rx-only reset it is left intact, + * and waiting for TEMT here would spin for a full frame time. + */ do { lsr = tegra_uart_read(tup, UART_LSR); - if ((lsr & UART_LSR_TEMT) && !(lsr & UART_LSR_DR)) + if ((!clear_tx || (lsr & UART_LSR_TEMT)) && + !(lsr & UART_LSR_DR)) break; udelay(1); } while (--tmout); |