selftests/bpf: Test packet range of pointers sharing an idgrafted

Add tests where two packet pointers share an id and tightening one
pointer's umax from its var_off would put it less than their constant
distance from the other's umax: with an index & 0x38 capped at 50, the
base pointer keeps umax 50, so the pointer 8 bytes further on must keep
umax 58, even though its known bits allow at most 56.

These refused a valid program or accepted an out-of-bounds access before
the fix:

- check the advanced copy, load through the base: valid, was refused;
- check the base, load the byte at base + 1 through a copy advanced by
  8: was accepted;
- check base + 4, load 4 bytes at base + 2 through base + 8: reads two
  bytes past the checked range, was accepted;
- the same as the second with data_meta pointers checked against data:
  was accepted.

These pass with and without the fix and cover nearby paths:

- subtract an unknown scalar from a checked pointer and load below it
  (the range is kept across a new id);
- reach a load through two paths whose checks cover 8 and 7 bytes after
  the loaded pointer; the second path must not be pruned by the first;
- spill a copy of a pointer, check the pointer, fill the copy and load
  one byte past the checked range: the load is refused, and the copy
  has the range of the check.

Signed-off-by: Alexei Starovoitov <ast@kernel.org>
Link: https://lore.kernel.org/bpf/20261001145255.855630-2-alexei.starovoitov@gmail.com
Signed-off-by: Kumar Kartikeya Dwivedi <memxor@gmail.com>

1 files changed, 36 insertions, 0 deletions

diff --git a/usr/initramfs_data.S b/usr/initramfs_data.S
new file mode 100644
index 000000000..e92fb59b3
--- /dev/null
+++ b/usr/initramfs_data.S
@@ -0,0 +1,36 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+/*
+  initramfs_data includes the compressed binary that is the
+  filesystem used for early user space.
+  Note: Older versions of "as" (prior to binutils 2.11.90.0.23
+  released on 2001-07-14) did not support .incbin.
+  If you are forced to use older binutils than that then the
+  following trick can be applied to create the resulting binary:
+
+
+  ld -m elf_i386  --format binary --oformat elf32-i386 -r \
+  -T initramfs_data.scr initramfs_data.cpio.gz -o initramfs_data.o
+   ld -m elf_i386  -r -o built-in.a initramfs_data.o
+
+  For including the .init.ramfs sections, see include/asm-generic/vmlinux.lds.
+
+  The above example is for i386 - the parameters vary from architectures.
+  Eventually look up LDFLAGS_BLOB in an older version of the
+  arch/$(ARCH)/Makefile to see the flags used before .incbin was introduced.
+
+  Using .incbin has the advantage over ld that the correct flags are set
+  in the ELF header, as required by certain architectures.
+*/
+
+.section .init.ramfs,"a"
+__irf_start:
+.incbin "usr/initramfs_inc_data"
+__irf_end:
+.section .init.ramfs.info,"a"
+.globl __initramfs_size
+__initramfs_size:
+#ifdef CONFIG_64BIT
+	.quad __irf_end - __irf_start
+#else
+	.long __irf_end - __irf_start
+#endif