selftests/bpf: Test packet range of pointers sharing an idgrafted

Add tests where two packet pointers share an id and tightening one
pointer's umax from its var_off would put it less than their constant
distance from the other's umax: with an index & 0x38 capped at 50, the
base pointer keeps umax 50, so the pointer 8 bytes further on must keep
umax 58, even though its known bits allow at most 56.

These refused a valid program or accepted an out-of-bounds access before
the fix:

- check the advanced copy, load through the base: valid, was refused;
- check the base, load the byte at base + 1 through a copy advanced by
  8: was accepted;
- check base + 4, load 4 bytes at base + 2 through base + 8: reads two
  bytes past the checked range, was accepted;
- the same as the second with data_meta pointers checked against data:
  was accepted.

These pass with and without the fix and cover nearby paths:

- subtract an unknown scalar from a checked pointer and load below it
  (the range is kept across a new id);
- reach a load through two paths whose checks cover 8 and 7 bytes after
  the loaded pointer; the second path must not be pruned by the first;
- spill a copy of a pointer, check the pointer, fill the copy and load
  one byte past the checked range: the load is refused, and the copy
  has the range of the check.

Signed-off-by: Alexei Starovoitov <ast@kernel.org>
Link: https://lore.kernel.org/bpf/20261001145255.855630-2-alexei.starovoitov@gmail.com
Signed-off-by: Kumar Kartikeya Dwivedi <memxor@gmail.com>

1 files changed, 13 insertions, 0 deletions

diff --git a/scripts/subarch.include b/scripts/subarch.include
new file mode 100644
index 000000000..c4592d59d
--- /dev/null
+++ b/scripts/subarch.include
@@ -0,0 +1,13 @@
+# SUBARCH tells the usermode build what the underlying arch is.  That is set
+# first, and if a usermode build is happening, the "ARCH=um" on the command
+# line overrides the setting of ARCH below.  If a native build is happening,
+# then ARCH is assigned, getting whatever value it gets normally, and
+# SUBARCH is subsequently ignored.
+
+SUBARCH := $(shell uname -m | sed -e s/i.86/x86/ -e s/x86_64/x86/ \
+				  -e s/sun4u/sparc64/ \
+				  -e /^arm64$$/!s/arm.*/arm/ -e s/sa110/arm/ \
+				  -e s/s390x/s390/ \
+				  -e s/ppc.*/powerpc/ -e s/mips.*/mips/ \
+				  -e s/sh[234].*/sh/ -e s/aarch64.*/arm64/ \
+				  -e s/riscv.*/riscv/ -e s/loongarch.*/loongarch/)