iio: proximity: vl53l0x-i2c: claim direct mode for raw readsgrafted

vl53l0x_read_raw() starts a single-shot ranging measurement and reads
back the result. Once the triggered buffer is enabled the sensor runs in
continuous mode and its data-ready interrupt is routed to the trigger,
so a concurrent in_distance_raw read disturbs the streaming setup and
never gets its completion, returning -ETIMEDOUT.

The original submission claimed direct mode here, but it was dropped
during review because the driver had no buffer support at the time [1].
Continuous (buffered) mode was later added without restoring the
claim [2], reintroducing the conflict.

Reject direct reads while buffered capture is active by claiming direct
mode around the measurement, as the vl53l1x sibling already does.

Fixes: 762186c6e7b1 ("iio: proximity: vl53l0x-i2c: Added continuous mode support")
Link: https://lore.kernel.org/linux-iio/20180911160300.GA9212@himanshu-Vostro-3559/ [1]
Link: https://lore.kernel.org/linux-iio/20240909101508.263085-3-abhashkumarjha123@gmail.com/ [2]
Signed-off-by: Donggeun Yoo <donggeunyoo.kernel@gmail.com>
Cc: stable@vger.kernel.org
Signed-off-by: Jonathan Cameron <jonathan.cameron@oss.qualcomm.com>

1 files changed, 44 insertions, 0 deletions

diff --git a/include/clocksource/timer-davinci.h b/include/clocksource/timer-davinci.h
new file mode 100644
index 000000000..1dcc1333f
--- /dev/null
+++ b/include/clocksource/timer-davinci.h
@@ -0,0 +1,44 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+/*
+ * TI DaVinci clocksource driver
+ *
+ * Copyright (C) 2019 Texas Instruments
+ * Author: Bartosz Golaszewski <bgolaszewski@baylibre.com>
+ */
+
+#ifndef __TIMER_DAVINCI_H__
+#define __TIMER_DAVINCI_H__
+
+#include <linux/clk.h>
+#include <linux/ioport.h>
+
+enum {
+	DAVINCI_TIMER_CLOCKEVENT_IRQ,
+	DAVINCI_TIMER_CLOCKSOURCE_IRQ,
+	DAVINCI_TIMER_NUM_IRQS,
+};
+
+/**
+ * struct davinci_timer_cfg - davinci clocksource driver configuration struct
+ * @reg:        register range resource
+ * @irq:        clockevent and clocksource interrupt resources
+ * @cmp_off:    if set - it specifies the compare register used for clockevent
+ *
+ * Note: if the compare register is specified, the driver will use the bottom
+ * clock half for both clocksource and clockevent and the compare register
+ * to generate event irqs. The user must supply the correct compare register
+ * interrupt number.
+ *
+ * This is only used by da830 the DSP of which uses the top half. The timer
+ * driver still configures the top half to run in free-run mode.
+ */
+struct davinci_timer_cfg {
+	struct resource reg;
+	struct resource irq[DAVINCI_TIMER_NUM_IRQS];
+	unsigned int cmp_off;
+};
+
+int __init davinci_timer_register(struct clk *clk,
+				  const struct davinci_timer_cfg *data);
+
+#endif /* __TIMER_DAVINCI_H__ */