selftests/bpf: Test packet range of pointers sharing an idgrafted

Add tests where two packet pointers share an id and tightening one
pointer's umax from its var_off would put it less than their constant
distance from the other's umax: with an index & 0x38 capped at 50, the
base pointer keeps umax 50, so the pointer 8 bytes further on must keep
umax 58, even though its known bits allow at most 56.

These refused a valid program or accepted an out-of-bounds access before
the fix:

- check the advanced copy, load through the base: valid, was refused;
- check the base, load the byte at base + 1 through a copy advanced by
  8: was accepted;
- check base + 4, load 4 bytes at base + 2 through base + 8: reads two
  bytes past the checked range, was accepted;
- the same as the second with data_meta pointers checked against data:
  was accepted.

These pass with and without the fix and cover nearby paths:

- subtract an unknown scalar from a checked pointer and load below it
  (the range is kept across a new id);
- reach a load through two paths whose checks cover 8 and 7 bytes after
  the loaded pointer; the second path must not be pruned by the first;
- spill a copy of a pointer, check the pointer, fill the copy and load
  one byte past the checked range: the load is refused, and the copy
  has the range of the check.

Signed-off-by: Alexei Starovoitov <ast@kernel.org>
Link: https://lore.kernel.org/bpf/20261001145255.855630-2-alexei.starovoitov@gmail.com
Signed-off-by: Kumar Kartikeya Dwivedi <memxor@gmail.com>

1 files changed, 108 insertions, 0 deletions

diff --git a/drivers/usb/chipidea/ulpi.c b/drivers/usb/chipidea/ulpi.c
new file mode 100644
index 000000000..dfec07e8a
--- /dev/null
+++ b/drivers/usb/chipidea/ulpi.c
@@ -0,0 +1,108 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (c) 2016 Linaro Ltd.
+ */
+
+#include <linux/device.h>
+#include <linux/usb/chipidea.h>
+#include <linux/ulpi/interface.h>
+
+#include "ci.h"
+
+#define ULPI_WAKEUP		BIT(31)
+#define ULPI_RUN		BIT(30)
+#define ULPI_WRITE		BIT(29)
+#define ULPI_SYNC_STATE		BIT(27)
+#define ULPI_ADDR(n)		((n) << 16)
+#define ULPI_DATA(n)		(n)
+
+static int ci_ulpi_wait(struct ci_hdrc *ci, u32 mask)
+{
+	unsigned long usec = 10000;
+
+	while (usec--) {
+		if (!hw_read(ci, OP_ULPI_VIEWPORT, mask))
+			return 0;
+
+		udelay(1);
+	}
+
+	return -ETIMEDOUT;
+}
+
+static int ci_ulpi_read(struct device *dev, u8 addr)
+{
+	struct ci_hdrc *ci = dev_get_drvdata(dev);
+	int ret;
+
+	hw_write(ci, OP_ULPI_VIEWPORT, 0xffffffff, ULPI_WRITE | ULPI_WAKEUP);
+	ret = ci_ulpi_wait(ci, ULPI_WAKEUP);
+	if (ret)
+		return ret;
+
+	hw_write(ci, OP_ULPI_VIEWPORT, 0xffffffff, ULPI_RUN | ULPI_ADDR(addr));
+	ret = ci_ulpi_wait(ci, ULPI_RUN);
+	if (ret)
+		return ret;
+
+	return hw_read(ci, OP_ULPI_VIEWPORT, GENMASK(15, 8)) >> 8;
+}
+
+static int ci_ulpi_write(struct device *dev, u8 addr, u8 val)
+{
+	struct ci_hdrc *ci = dev_get_drvdata(dev);
+	int ret;
+
+	hw_write(ci, OP_ULPI_VIEWPORT, 0xffffffff, ULPI_WRITE | ULPI_WAKEUP);
+	ret = ci_ulpi_wait(ci, ULPI_WAKEUP);
+	if (ret)
+		return ret;
+
+	hw_write(ci, OP_ULPI_VIEWPORT, 0xffffffff,
+		 ULPI_RUN | ULPI_WRITE | ULPI_ADDR(addr) | val);
+	return ci_ulpi_wait(ci, ULPI_RUN);
+}
+
+int ci_ulpi_init(struct ci_hdrc *ci)
+{
+	if (ci->platdata->phy_mode != USBPHY_INTERFACE_MODE_ULPI)
+		return 0;
+
+	/*
+	 * Set PORTSC correctly so we can read/write ULPI registers for
+	 * identification purposes
+	 */
+	hw_phymode_configure(ci);
+
+	ci->ulpi_ops.read = ci_ulpi_read;
+	ci->ulpi_ops.write = ci_ulpi_write;
+	ci->ulpi = ulpi_register_interface(ci->dev, &ci->ulpi_ops);
+	if (IS_ERR(ci->ulpi))
+		dev_err(ci->dev, "failed to register ULPI interface");
+
+	return PTR_ERR_OR_ZERO(ci->ulpi);
+}
+
+void ci_ulpi_exit(struct ci_hdrc *ci)
+{
+	if (ci->ulpi) {
+		ulpi_unregister_interface(ci->ulpi);
+		ci->ulpi = NULL;
+	}
+}
+
+int ci_ulpi_resume(struct ci_hdrc *ci)
+{
+	int cnt = 100000;
+
+	if (ci->platdata->phy_mode != USBPHY_INTERFACE_MODE_ULPI)
+		return 0;
+
+	while (cnt-- > 0) {
+		if (hw_read(ci, OP_ULPI_VIEWPORT, ULPI_SYNC_STATE))
+			return 0;
+		udelay(1);
+	}
+
+	return -ETIMEDOUT;
+}