Merge tag 'pinctrl-v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrlgrafted

Pull pin control updates from Linus Walleij:
 "Core changes:

   - Use the non-blocking mux_state_try_select() in the generic MUX pin
     control back-end

   - Free pin maps on pinctrl_generic_to_map() failure in the core
     helpers

  New hardware pin control:

   - Qualcomm Maili TLMM SoC, PMG1110 PMIC, and Eliza LPASS LPI TLMM SoC
     (this is for the low power audio, LPASS = Low Power Audio SubSystem
     portions)

   - Upboard support on top of the Intel pin controller

   - Apple T6030 and T6031 support (just compatible strings)

   - Samsung Exynos 8855 SoC

   - Mediatek MT6858 SoC

   - Rockchip RK3308B and RV1106 SoCs

   - Airoha EN7523 and AN7563 SoCs

  Improvements:

   - Qualcomm TLMM GPIOs are unconditionally marked as wakeup capable

   - Qualcomm improvements on top of the Qualcomm PDC (power domain
     controller) irqchip improvements from tglx:s tree

   - Qualcomm IPQ806x and IPQ9650 non-urgent pin grop fixups

   - The NPCM8xx driver has been put into shape fixing many pin and
     group definitions

   - Some non-urgent Tegra 264 pin assignments are fixed up

   - Some non-urgent fixups to Airoha AN7581 and AN7583 registers and
     pin assignments, missing features etc"

* tag 'pinctrl-v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (130 commits)
  dt-bindings: pinctrl: Convert TI DA850 pupd to DT schema
  pinctrl: meson: sync some modify from A4
  pinctrl: meson: a4: Add input enable pin configuration
  pinctrl: realtek: rtd1625: remove unused group name spdif_sel
  pinctrl: realtek: rtd1625: fix base_bit for VE4 GPIO 13
  dt-bindings: pinctrl: microchip,pic32mzda-pinctrl: Convert to DT schema
  Revert "Merge branch 'ib-rsk7204' into devel"
  pinctrl: rockchip: Add RV1106 pinctrl support
  dt-bindings: pinctrl: rockchip: Add RV1106 compatible
  pinctrl: rockchip: Decode drive strength in the get function
  pinctrl: fix PINCTRL_GENERIC_MUX not always being selectable
  pinctrl: airoha: add support of an7563 SoC
  dt-bindings: pinctrl: airoha: add support of an7563 pin controller
  pinctrl: airoha: try to find chip scu node by phandle first
  pinctrl: airoha: add support of en7523 SoC
  dt-bindings: pinctrl: airoha: add support of en7523 pin controller
  pinctrl: airoha: an7583: add support for olt pinmux
  pinctrl: airoha: an7583: add support for pon_alt pinmux
  pinctrl: airoha: an7583: add support for npu_uart pinmux
  dt-bindings: pinctrl: airoha: an7583: add missed features
  ...

1 files changed, 178 insertions, 0 deletions

diff --git a/arch/arc/mm/init.c b/arch/arc/mm/init.c
new file mode 100644
index 000000000..d6b5c27a0
--- /dev/null
+++ b/arch/arc/mm/init.c
@@ -0,0 +1,178 @@
+// SPDX-License-Identifier: GPL-2.0-only
+/*
+ * Copyright (C) 2004, 2007-2010, 2011-2012 Synopsys, Inc. (www.synopsys.com)
+ */
+
+#include <linux/kernel.h>
+#include <linux/mm.h>
+#include <linux/memblock.h>
+#ifdef CONFIG_BLK_DEV_INITRD
+#include <linux/initrd.h>
+#endif
+#include <linux/of_fdt.h>
+#include <linux/swap.h>
+#include <linux/module.h>
+#include <linux/highmem.h>
+#include <asm/page.h>
+#include <asm/sections.h>
+#include <asm/setup.h>
+#include <asm/arcregs.h>
+
+pgd_t swapper_pg_dir[PTRS_PER_PGD] __aligned(PAGE_SIZE);
+
+static const unsigned long low_mem_start = CONFIG_LINUX_RAM_BASE;
+static unsigned long low_mem_sz;
+
+#ifdef CONFIG_HIGHMEM
+static unsigned long min_high_pfn, max_high_pfn;
+static phys_addr_t high_mem_start;
+static phys_addr_t high_mem_sz;
+unsigned long arch_pfn_offset;
+EXPORT_SYMBOL(arch_pfn_offset);
+#endif
+
+long __init arc_get_mem_sz(void)
+{
+	return low_mem_sz;
+}
+
+/* User can over-ride above with "mem=nnn[KkMm]" in cmdline */
+static int __init setup_mem_sz(char *str)
+{
+	low_mem_sz = memparse(str, NULL) & PAGE_MASK;
+
+	/* early console might not be setup yet - it will show up later */
+	pr_info("\"mem=%s\": mem sz set to %ldM\n", str, TO_MB(low_mem_sz));
+
+	return 0;
+}
+early_param("mem", setup_mem_sz);
+
+void __init early_init_dt_add_memory_arch(u64 base, u64 size)
+{
+	int in_use = 0;
+
+	if (!low_mem_sz) {
+		if (base != low_mem_start)
+			panic("CONFIG_LINUX_RAM_BASE != DT memory { }");
+
+		low_mem_sz = size;
+		in_use = 1;
+		memblock_add_node(base, size, 0, MEMBLOCK_NONE);
+	} else {
+#ifdef CONFIG_HIGHMEM
+		high_mem_start = base;
+		high_mem_sz = size;
+		in_use = 1;
+		memblock_add_node(base, size, 1, MEMBLOCK_NONE);
+		memblock_reserve(base, size);
+#endif
+	}
+
+	pr_info("Memory @ %llx [%lldM] %s\n",
+		base, TO_MB(size), !in_use ? "Not used":"");
+}
+
+void __init arch_zone_limits_init(unsigned long *max_zone_pfn)
+{
+	/*----------------- node/zones setup --------------------------*/
+	max_zone_pfn[ZONE_NORMAL] = max_low_pfn;
+
+#ifdef CONFIG_HIGHMEM
+	/*
+	 * max_high_pfn should be ok here for both HIGHMEM and HIGHMEM+PAE.
+	 * For HIGHMEM without PAE max_high_pfn should be less than
+	 * min_low_pfn to guarantee that these two regions don't overlap.
+	 * For PAE case highmem is greater than lowmem, so it is natural
+	 * to use max_high_pfn.
+	 *
+	 * In both cases, holes should be handled by pfn_valid().
+	 */
+	max_zone_pfn[ZONE_HIGHMEM] = max_high_pfn;
+#endif
+}
+
+/*
+ * First memory setup routine called from setup_arch()
+ * 1. setup swapper's mm @init_mm
+ * 2. Count the pages we have and setup bootmem allocator
+ * 3. zone setup
+ */
+void __init setup_arch_memory(void)
+{
+	setup_initial_init_mm(_text, _etext, _edata, _end);
+
+	/* first page of system - kernel .vector starts here */
+	min_low_pfn = virt_to_pfn((void *)CONFIG_LINUX_RAM_BASE);
+
+	/* Last usable page of low mem */
+	max_low_pfn = max_pfn = PFN_DOWN(low_mem_start + low_mem_sz);
+
+	/*------------- bootmem allocator setup -----------------------*/
+
+	/*
+	 * seed the bootmem allocator after any DT memory node parsing or
+	 * "mem=xxx" cmdline overrides have potentially updated @arc_mem_sz
+	 *
+	 * Only low mem is added, otherwise we have crashes when allocating
+	 * mem_map[] itself. NO_BOOTMEM allocates mem_map[] at the end of
+	 * avail memory, ending in highmem with a > 32-bit address. However
+	 * it then tries to memset it with a truncaed 32-bit handle, causing
+	 * the crash
+	 */
+
+	memblock_reserve(CONFIG_LINUX_LINK_BASE,
+			 __pa(_end) - CONFIG_LINUX_LINK_BASE);
+
+#ifdef CONFIG_BLK_DEV_INITRD
+	if (phys_initrd_size) {
+		memblock_reserve(phys_initrd_start, phys_initrd_size);
+		initrd_start = (unsigned long)__va(phys_initrd_start);
+		initrd_end = initrd_start + phys_initrd_size;
+	}
+#endif
+
+	early_init_fdt_reserve_self();
+	early_init_fdt_scan_reserved_mem();
+
+	memblock_dump_all();
+
+#ifdef CONFIG_HIGHMEM
+	/*
+	 * On ARC (w/o PAE) HIGHMEM addresses are actually smaller (0 based)
+	 * than addresses in normal aka low memory (0x8000_0000 based).
+	 * Even with PAE, the huge peripheral space hole would waste a lot of
+	 * mem with single contiguous mem_map[].
+	 * Thus when HIGHMEM on ARC is enabled the memory map corresponding
+	 * to the hole is freed and ARC specific version of pfn_valid()
+	 * handles the hole in the memory map.
+	 */
+
+	min_high_pfn = PFN_DOWN(high_mem_start);
+	max_high_pfn = PFN_DOWN(high_mem_start + high_mem_sz);
+
+	arch_pfn_offset = min(min_low_pfn, min_high_pfn);
+	kmap_init();
+#endif /* CONFIG_HIGHMEM */
+}
+
+void __init arch_mm_preinit(void)
+{
+#ifdef CONFIG_HIGHMEM
+	memblock_phys_free(high_mem_start, high_mem_sz);
+#endif
+
+	BUILD_BUG_ON((PTRS_PER_PGD * sizeof(pgd_t)) > PAGE_SIZE);
+	BUILD_BUG_ON((PTRS_PER_PUD * sizeof(pud_t)) > PAGE_SIZE);
+	BUILD_BUG_ON((PTRS_PER_PMD * sizeof(pmd_t)) > PAGE_SIZE);
+	BUILD_BUG_ON((PTRS_PER_PTE * sizeof(pte_t)) > PAGE_SIZE);
+}
+
+#ifdef CONFIG_HIGHMEM
+int pfn_valid(unsigned long pfn)
+{
+	return (pfn >= min_high_pfn && pfn <= max_high_pfn) ||
+		(pfn >= min_low_pfn && pfn <= max_low_pfn);
+}
+EXPORT_SYMBOL(pfn_valid);
+#endif