iio: proximity: vl53l0x-i2c: claim direct mode for raw readsgrafted

vl53l0x_read_raw() starts a single-shot ranging measurement and reads
back the result. Once the triggered buffer is enabled the sensor runs in
continuous mode and its data-ready interrupt is routed to the trigger,
so a concurrent in_distance_raw read disturbs the streaming setup and
never gets its completion, returning -ETIMEDOUT.

The original submission claimed direct mode here, but it was dropped
during review because the driver had no buffer support at the time [1].
Continuous (buffered) mode was later added without restoring the
claim [2], reintroducing the conflict.

Reject direct reads while buffered capture is active by claiming direct
mode around the measurement, as the vl53l1x sibling already does.

Fixes: 762186c6e7b1 ("iio: proximity: vl53l0x-i2c: Added continuous mode support")
Link: https://lore.kernel.org/linux-iio/20180911160300.GA9212@himanshu-Vostro-3559/ [1]
Link: https://lore.kernel.org/linux-iio/20240909101508.263085-3-abhashkumarjha123@gmail.com/ [2]
Signed-off-by: Donggeun Yoo <donggeunyoo.kernel@gmail.com>
Cc: stable@vger.kernel.org
Signed-off-by: Jonathan Cameron <jonathan.cameron@oss.qualcomm.com>

1 files changed, 49 insertions, 0 deletions

diff --git a/Documentation/networking/alias.rst b/Documentation/networking/alias.rst
new file mode 100644
index 000000000..af7c5ee92
--- /dev/null
+++ b/Documentation/networking/alias.rst
@@ -0,0 +1,49 @@
+.. SPDX-License-Identifier: GPL-2.0
+
+===========
+IP-Aliasing
+===========
+
+IP-aliases are an obsolete way to manage multiple IP-addresses/masks
+per interface. Newer tools such as iproute2 support multiple
+address/prefixes per interface, but aliases are still supported
+for backwards compatibility.
+
+An alias is formed by adding a colon and a string when running ifconfig.
+This string is usually numeric, but this is not a must.
+
+
+Alias creation
+==============
+
+Alias creation is done by 'magic' interface naming: eg. to create a
+200.1.1.1 alias for eth0 ...
+::
+
+  # ifconfig eth0:0 200.1.1.1  etc,etc....
+	~~ -> request alias #0 creation (if not yet exists) for eth0
+
+The corresponding route is also set up by this command.  Please note:
+The route always points to the base interface.
+
+
+Alias deletion
+==============
+
+The alias is removed by shutting the alias down::
+
+  # ifconfig eth0:0 down
+	~~~~~~~~~~ -> will delete alias
+
+
+Alias (re-)configuring
+======================
+
+Aliases are not real devices, but programs should be able to configure
+and refer to them as usual (ifconfig, route, etc).
+
+
+Relationship with main device
+=============================
+
+If the base device is shut down the added aliases will be deleted too.