openrisc: fix arbitrary kernel memory access via or1k_atomic syscallgrafted

sys_or1k_atomic() (syscall 244 in the "or1k" ABI) takes two user
pointers, v1 and v2, and swaps the words they point to in hand-written
assembly.

    l.lwz   r29,0(r4)
    l.lwz   r27,0(r5)
    l.sw    0(r4),r27
    l.sw    0(r5),r29

The pointers are not checked with access_ok(). The four memory
accesses also have no exception table entries.

A caller passes a kernel address as either pointer, and the syscall
reads from and writes to it directly.

This gives an unprivileged process a kernel read/write primitive. It
overwrites kernel data such as the sys_call_table, gaining code
execution in kernel context.

Check both pointers before entering the critical section. Add fixups
for the four memory accesses so faults on valid but unmapped user
addresses return -EFAULT.

[shorne@gmail.com: fix comment style]
Fixes: 9d02a4283e9c ("OpenRISC: Boot code")
Cc: stable@vger.kernel.org
Signed-off-by: Ali Ahmet Memis <ali@iusegentoo.com>
Signed-off-by: Stafford Horne <shorne@gmail.com>

1 files changed, 29 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/regmap/regmap.txt b/Documentation/devicetree/bindings/regmap/regmap.txt
new file mode 100644
index 000000000..873096be0
--- /dev/null
+++ b/Documentation/devicetree/bindings/regmap/regmap.txt
@@ -0,0 +1,29 @@
+Devicetree binding for regmap
+
+Optional properties:
+
+   little-endian,
+   big-endian,
+   native-endian:	See common-properties.txt for a definition
+
+Note:
+Regmap defaults to little-endian register access on MMIO based
+devices, this is by far the most common setting. On CPU
+architectures that typically run big-endian operating systems
+(e.g. PowerPC), registers can be defined as big-endian and must
+be marked that way in the devicetree.
+
+On SoCs that can be operated in both big-endian and little-endian
+modes, with a single hardware switch controlling both the endianness
+of the CPU and a byteswap for MMIO registers (e.g. many Broadcom MIPS
+chips), "native-endian" is used to allow using the same device tree
+blob in both cases.
+
+Examples:
+Scenario 1 : a register set in big-endian mode.
+dev: dev@40031000 {
+	      compatible = "syscon";
+	      reg = <0x40031000 0x1000>;
+	      big-endian;
+	      ...
+};