iio: proximity: vl53l0x-i2c: claim direct mode for raw readsgrafted

vl53l0x_read_raw() starts a single-shot ranging measurement and reads
back the result. Once the triggered buffer is enabled the sensor runs in
continuous mode and its data-ready interrupt is routed to the trigger,
so a concurrent in_distance_raw read disturbs the streaming setup and
never gets its completion, returning -ETIMEDOUT.

The original submission claimed direct mode here, but it was dropped
during review because the driver had no buffer support at the time [1].
Continuous (buffered) mode was later added without restoring the
claim [2], reintroducing the conflict.

Reject direct reads while buffered capture is active by claiming direct
mode around the measurement, as the vl53l1x sibling already does.

Fixes: 762186c6e7b1 ("iio: proximity: vl53l0x-i2c: Added continuous mode support")
Link: https://lore.kernel.org/linux-iio/20180911160300.GA9212@himanshu-Vostro-3559/ [1]
Link: https://lore.kernel.org/linux-iio/20240909101508.263085-3-abhashkumarjha123@gmail.com/ [2]
Signed-off-by: Donggeun Yoo <donggeunyoo.kernel@gmail.com>
Cc: stable@vger.kernel.org
Signed-off-by: Jonathan Cameron <jonathan.cameron@oss.qualcomm.com>

1 files changed, 40 insertions, 0 deletions

diff --git a/Documentation/admin-guide/nfs/nfsd-admin-interfaces.rst b/Documentation/admin-guide/nfs/nfsd-admin-interfaces.rst
new file mode 100644
index 000000000..c05926f79
--- /dev/null
+++ b/Documentation/admin-guide/nfs/nfsd-admin-interfaces.rst
@@ -0,0 +1,40 @@
+==================================
+Administrative interfaces for nfsd
+==================================
+
+Note that normally these interfaces are used only by the utilities in
+nfs-utils.
+
+nfsd is controlled mainly by pseudofiles under the "nfsd" filesystem,
+which is normally mounted at /proc/fs/nfsd/.
+
+The server is always started by the first write of a nonzero value to
+nfsd/threads.
+
+Before doing that, NFSD can be told which sockets to listen on by
+writing to nfsd/portlist; that write may be:
+
+	-  an ascii-encoded file descriptor, which should refer to a
+	   bound (and listening, for tcp) socket, or
+	-  "transportname port", where transportname is currently either
+	   "udp", "tcp", or "rdma".
+
+If nfsd is started without doing any of these, then it will create one
+udp and one tcp listener at port 2049 (see nfsd_init_socks).
+
+On startup, nfsd and lockd grace periods start. nfsd is shut down by a write of
+0 to nfsd/threads.  All locks and state are thrown away at that point.
+
+Between startup and shutdown, the number of threads may be adjusted up
+or down by additional writes to nfsd/threads or by writes to
+nfsd/pool_threads.
+
+For more detail about files under nfsd/ and what they control, see
+fs/nfsd/nfsctl.c; most of them have detailed comments.
+
+Implementation notes
+====================
+
+Note that the rpc server requires the caller to serialize addition and
+removal of listening sockets, and startup and shutdown of the server.
+For nfsd this is done using nfsd_mutex.