ftrace: Synchronize the initialization of ftrace_opsgrafted

There's some internal state that ftrace_ops needs to have set, but since
it can be declared outside of the ftrace.c code, it calls
ftrace_ops_init() on the ops in every global function. The issue is that
if two tasks call it on the same ops at the same time it is possible to
have the initialization of one corrupt the initialization of the other
call.

Create a ops_mutex to use to synchronize every initialization of the
ftrace_ops. The mutex is taken within checking the ftrace_ops flag that
states it was initializied but the flag is checked again after the mutex
has been taken. Checking first outside the mutex allows it to shortcut
having to take the mutex. But then the check needs to be done again after
the mute is taken in case of races.

Cc: stable@vger.kernel.org
Link: https://patch.msgid.link/20260902095501.6b59af20@gandalf.local.home
Fixes: f04f24fb7e48d ("ftrace, kprobes: Fix a deadlock on ftrace_regex_lock")
Reported-by: sashiko-bot@kernel.org
Close: https://lore.kernel.org/all/20260829025528.49A831F000E9@smtp.kernel.org/
Signed-off-by: Steven Rostedt <rostedt@goodmis.org>

1 files changed, 38 insertions, 0 deletions

diff --git a/Documentation/admin-guide/braille-console.rst b/Documentation/admin-guide/braille-console.rst
new file mode 100644
index 000000000..153472e93
--- /dev/null
+++ b/Documentation/admin-guide/braille-console.rst
@@ -0,0 +1,38 @@
+Linux Braille Console
+=====================
+
+To get early boot messages on a braille device (before userspace screen
+readers can start), you first need to compile the support for the usual serial
+console (see :ref:`Documentation/admin-guide/serial-console.rst <serial_console>`), and
+for braille device
+(in :menuselection:`Device Drivers --> Accessibility support --> Console on braille device`).
+
+Then you need to specify a ``console=brl``, option on the kernel command line, the
+format is::
+
+	console=brl,serial_options...
+
+where ``serial_options...`` are the same as described in
+:ref:`Documentation/admin-guide/serial-console.rst <serial_console>`.
+
+So for instance you can use ``console=brl,ttyS0`` if the braille device is connected to the first serial port, and ``console=brl,ttyS0,115200`` to
+override the baud rate to 115200, etc.
+
+By default, the braille device will just show the last kernel message (console
+mode).  To review previous messages, press the Insert key to switch to the VT
+review mode.  In review mode, the arrow keys permit to browse in the VT content,
+`PAGE-UP`/`PAGE-DOWN` keys go at the top/bottom of the screen, and
+the `HOME` key goes back
+to the cursor, hence providing very basic screen reviewing facility.
+
+Sound feedback can be obtained by adding the ``braille_console.sound=1`` kernel
+parameter.
+
+For simplicity, only one braille console can be enabled, other uses of
+``console=brl,...`` will be discarded.  Also note that it does not interfere with
+the console selection mechanism described in
+:ref:`Documentation/admin-guide/serial-console.rst <serial_console>`.
+
+For now, only the VisioBraille device is supported.
+
+Samuel Thibault <samuel.thibault@ens-lyon.org>