From 33a154a96e71a34a1bcca9f40da343dbbf7b38b4 Mon Sep 17 00:00:00 2001 From: Alexei Starovoitov Date: Thu, 1 Oct 2026 14:52:55 +0000 Subject: selftests/bpf: Test packet range of pointers sharing an id Add tests where two packet pointers share an id and tightening one pointer's umax from its var_off would put it less than their constant distance from the other's umax: with an index & 0x38 capped at 50, the base pointer keeps umax 50, so the pointer 8 bytes further on must keep umax 58, even though its known bits allow at most 56. These refused a valid program or accepted an out-of-bounds access before the fix: - check the advanced copy, load through the base: valid, was refused; - check the base, load the byte at base + 1 through a copy advanced by 8: was accepted; - check base + 4, load 4 bytes at base + 2 through base + 8: reads two bytes past the checked range, was accepted; - the same as the second with data_meta pointers checked against data: was accepted. These pass with and without the fix and cover nearby paths: - subtract an unknown scalar from a checked pointer and load below it (the range is kept across a new id); - reach a load through two paths whose checks cover 8 and 7 bytes after the loaded pointer; the second path must not be pruned by the first; - spill a copy of a pointer, check the pointer, fill the copy and load one byte past the checked range: the load is refused, and the copy has the range of the check. Signed-off-by: Alexei Starovoitov Link: https://lore.kernel.org/bpf/20261001145255.855630-2-alexei.starovoitov@gmail.com Signed-off-by: Kumar Kartikeya Dwivedi --- include/clocksource/timer-davinci.h | 44 +++++++++++++++++++++++++++++++++++++ 1 file changed, 44 insertions(+) create mode 100644 include/clocksource/timer-davinci.h (limited to 'include/clocksource/timer-davinci.h') diff --git a/include/clocksource/timer-davinci.h b/include/clocksource/timer-davinci.h new file mode 100644 index 000000000..1dcc1333f --- /dev/null +++ b/include/clocksource/timer-davinci.h @@ -0,0 +1,44 @@ +/* SPDX-License-Identifier: GPL-2.0-only */ +/* + * TI DaVinci clocksource driver + * + * Copyright (C) 2019 Texas Instruments + * Author: Bartosz Golaszewski + */ + +#ifndef __TIMER_DAVINCI_H__ +#define __TIMER_DAVINCI_H__ + +#include +#include + +enum { + DAVINCI_TIMER_CLOCKEVENT_IRQ, + DAVINCI_TIMER_CLOCKSOURCE_IRQ, + DAVINCI_TIMER_NUM_IRQS, +}; + +/** + * struct davinci_timer_cfg - davinci clocksource driver configuration struct + * @reg: register range resource + * @irq: clockevent and clocksource interrupt resources + * @cmp_off: if set - it specifies the compare register used for clockevent + * + * Note: if the compare register is specified, the driver will use the bottom + * clock half for both clocksource and clockevent and the compare register + * to generate event irqs. The user must supply the correct compare register + * interrupt number. + * + * This is only used by da830 the DSP of which uses the top half. The timer + * driver still configures the top half to run in free-run mode. + */ +struct davinci_timer_cfg { + struct resource reg; + struct resource irq[DAVINCI_TIMER_NUM_IRQS]; + unsigned int cmp_off; +}; + +int __init davinci_timer_register(struct clk *clk, + const struct davinci_timer_cfg *data); + +#endif /* __TIMER_DAVINCI_H__ */ -- cgit v1.3.1