From dd05add7b2b6004c5fa3a1f276f56d8668f86b65 Mon Sep 17 00:00:00 2001 From: Paulo Alcantara Date: Sat, 26 Sep 2026 19:20:30 -0300 Subject: netfs: zero the tail of a short DIO/unbuffered read The buffered read collector zero-fills the tail of a short read that stops below the inode's i_size (netfs_clear_unread()), so a read that races an extending write still returns the expected number of bytes. The non-buffered collector path does no such thing: it just records how much was transferred. Add the same zero-fill for the non-buffered case, gated on NETFS_SREQ_CLEAR_TAIL: a subreq's source sets that flag when a short result from it is known to be safe to treat as a hole, as opposed to NETFS_SREQ_HIT_EOF, which means the read genuinely ran off the end of the file and should be reported short as-is. Only CLEAR_TAIL should zero-fill here; a real EOF must stay a real short read. No source currently sets CLEAR_TAIL on an unbuffered/DIO subrequest, so this is inert on its own -- a following change teaches cifs to set it in the one case that needs it. Fixes: e2d46f2ec332 ("netfs: Change the read result collector to only use one work item") Reviewed-by: David Howells Reviewed-by: Namjae Jeon Signed-off-by: Paulo Alcantara Cc: Christian Brauner Cc: Matthew Wilcox Cc: Ronnie Sahlberg Cc: Shyam Prasad N Cc: Tom Talpey Cc: Bharath SM Cc: stable@vger.kernel.org --- drivers/usb/image/Kconfig | 29 +++++++++++++++++++++++++++++ 1 file changed, 29 insertions(+) create mode 100644 drivers/usb/image/Kconfig (limited to 'drivers/usb/image/Kconfig') diff --git a/drivers/usb/image/Kconfig b/drivers/usb/image/Kconfig new file mode 100644 index 000000000..a65c638e7 --- /dev/null +++ b/drivers/usb/image/Kconfig @@ -0,0 +1,29 @@ +# SPDX-License-Identifier: GPL-2.0 +# +# USB Imaging devices configuration +# +comment "USB Imaging devices" + +config USB_MDC800 + tristate "USB Mustek MDC800 Digital Camera support" + help + Say Y here if you want to connect this type of still camera to + your computer's USB port. This driver can be used with gphoto 0.4.3 + and higher (look at ). + To use it create a device node with "mknod /dev/mustek c 180 32" and + configure it in your software. + + To compile this driver as a module, choose M here: the + module will be called mdc800. + +config USB_MICROTEK + tristate "Microtek X6USB scanner support" + depends on SCSI + help + Say Y here if you want support for the Microtek X6USB and + possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. + Support for anything but the X6 is experimental. + Please report failures and successes. + The scanner will appear as a scsi generic device to the rest + of the system. Scsi support is required. + This driver can be compiled as a module, called microtek. -- cgit v1.3.1