From 6668ed271eaefaa63e686bdfbedaeb7b8e492722 Mon Sep 17 00:00:00 2001 From: Kumar Kartikeya Dwivedi Date: Fri, 4 Sep 2026 10:43:19 +0200 Subject: selftests/bpf: Reject graph kptr use after RCU unlock Add a sleepable verifier test that loads a graph-node local kptr in an explicit RCU read-side critical section, then passes its node to bpf_rbtree_remove() after the section ends. Before the verifier fix, the stale NON_OWN_REF flag makes the node look like a live borrowed reference and the program is accepted. After the fix, the pointer is demoted without NON_OWN_REF and the graph kfunc argument is rejected. Also exercise a graph kptr loaded while a spin lock provides implicit RCU protection. The pointer must be invalidated when the lock is released, which guards the required ordering between non-owning-reference invalidation and RCU demotion. Update the existing fault-protected load test state description. The post-unlock pointer no longer carries NON_OWN_REF, but remains readable because the load is rewritten to use BPF_PROBE_MEM. Signed-off-by: Kumar Kartikeya Dwivedi Link: https://lore.kernel.org/r/20260904084325.52250-7-memxor@gmail.com Signed-off-by: Alexei Starovoitov --- drivers/hwmon/occ/Kconfig | 35 +++++++++++++++++++++++++++++++++++ 1 file changed, 35 insertions(+) create mode 100644 drivers/hwmon/occ/Kconfig (limited to 'drivers/hwmon/occ/Kconfig') diff --git a/drivers/hwmon/occ/Kconfig b/drivers/hwmon/occ/Kconfig new file mode 100644 index 000000000..348c21100 --- /dev/null +++ b/drivers/hwmon/occ/Kconfig @@ -0,0 +1,35 @@ +# SPDX-License-Identifier: GPL-2.0-only +# +# On-Chip Controller configuration +# + +config SENSORS_OCC_P8_I2C + tristate "POWER8 OCC through I2C" + depends on I2C + select SENSORS_OCC + help + This option enables support for monitoring sensors provided by the + On-Chip Controller (OCC) on a POWER8 processor. However, this driver + can only run on a baseboard management controller (BMC) connected to + the P8, not the POWER processor itself. Communications with the OCC are + established through I2C bus. + + This driver can also be built as a module. If so, the module will be + called occ-p8-hwmon. + +config SENSORS_OCC_P9_SBE + tristate "POWER9 OCC through SBE" + depends on FSI_OCC + select SENSORS_OCC + help + This option enables support for monitoring sensors provided by the + On-Chip Controller (OCC) on a POWER9 processor. However, this driver + can only run on a baseboard management controller (BMC) connected to + the P9, not the POWER processor itself. Communications with the OCC are + established through SBE fifo on an FSI bus. + + This driver can also be built as a module. If so, the module will be + called occ-p9-hwmon. + +config SENSORS_OCC + tristate -- cgit v1.3.1