From 4352b8aee98005853aa63f57d6377282de17a33f Mon Sep 17 00:00:00 2001 From: Linus Torvalds Date: Sun, 23 Aug 2026 13:28:57 -0700 Subject: Merge tag 'i3c/for-7.3' of git://git.kernel.org/pub/scm/linux/kernel/git/i3c/linux Pull I3C updates from Alexandre Belloni: "A new driver this cycle, for the AMD AXI I3C controller. There are also new features such as IBI wakeup support, SETAASA device discovery and ACPI support for the the DAA methods, meaning we can now communicate with the SPD devices on DDR5 modules. New driver: - AMD AXI I3C master controller Subsystem: - I3C Common Command Code (CCC) handling improvements, especially around GET CCCs - SETAASA device discovery support - ACPI support for all existing DAA methods like SETDASA, SETNEWDA as well as I2C devices on I3C bus - IBI-based wakeup support Drivers: - dw: SETAASA support - mipi-i3c-hci: advertise IBI wakeup capability, AMD_PT I3C controller support, PIO queue management support for HCI v1.2 - renesas: improve suspend to RAM support, add runtime PM support" * tag 'i3c/for-7.3' of git://git.kernel.org/pub/scm/linux/kernel/git/i3c/linux: (70 commits) i3c: dw: reduce do_daa time if there's no client i3c: mipi-i3c-hci: Add support for AMD_PT I3C controller i3c: mipi-i3c-hci: Add PIO queue management support for HCI v1.2 i3c: mipi-i3c-hci: Fix missing STAT_IBI_STATUS_THLD in PIO mode i3c: dw: rename "pclk" to "apb" to match dt-binding i3c: dw: make struct dw_i3c_cmd smaller i3c: dw: use COMMAND_PORT_TRANSFER_ARG instead of hardcoding i3c: renesas: Don't register devices when ENTDAA times out i3c: master: dw-i3c-master: fix OD timing for first broadcast i3c: mipi-i3c-hci: Advertise IBI wakeup capability i3c: mipi-i3c-hci: Factor out i3c_hci_sysdev() i3c: mipi-i3c-hci-pci: Propagate I3C wakeup requirements to PCI i3c: master: Reject IBI requests from non-IBI-capable devices i3c: master: Add helper to query bus wakeup requirements i3c: master: Report wakeup events for IBIs i3c: master: Support IBI-based wakeup capability i3c: master: Fix potential UAF in i3c_device_match() i3c: master: Fix potential UAF in i3c_device_uevent() i3c: Make dev->desc locking assumptions explicit i3c: master: Fix use-after-free of master->this ... --- arch/mips/bmips/setup.c | 253 ++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 253 insertions(+) create mode 100644 arch/mips/bmips/setup.c (limited to 'arch/mips/bmips/setup.c') diff --git a/arch/mips/bmips/setup.c b/arch/mips/bmips/setup.c new file mode 100644 index 000000000..2572fd49a --- /dev/null +++ b/arch/mips/bmips/setup.c @@ -0,0 +1,253 @@ +/* + * This file is subject to the terms and conditions of the GNU General Public + * License. See the file "COPYING" in the main directory of this archive + * for more details. + * + * Copyright (C) 2008 Maxime Bizon + * Copyright (C) 2014 Kevin Cernekee + */ + +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include + +#define RELO_NORMAL_VEC BIT(18) + +#define REG_BCM6328_OTP ((void __iomem *)CKSEG1ADDR(0x1000062c)) +#define BCM6328_TP1_DISABLED BIT(9) + +/* + * CBR addr doesn't change and we can cache it. + * For broken SoC/Bootloader CBR addr might also be provided via DT + * with "brcm,bmips-cbr-reg" in the "cpus" node. + */ +void __iomem *bmips_cbr_addr __read_mostly; + +extern bool bmips_rac_flush_disable; + +static const unsigned long kbase = VMLINUX_LOAD_ADDRESS & 0xfff00000; + +struct bmips_quirk { + const char *compatible; + void (*quirk_fn)(void); +}; + +static void kbase_setup(void) +{ + __raw_writel(kbase | RELO_NORMAL_VEC, + BMIPS_GET_CBR() + BMIPS_RELO_VECTOR_CONTROL_1); + ebase = kbase; +} + +static void bcm3384_viper_quirks(void) +{ + /* + * Some experimental CM boxes are set up to let CM own the Viper TP0 + * and let Linux own TP1. This requires moving the kernel + * load address to a non-conflicting region (e.g. via + * CONFIG_PHYSICAL_START) and supplying an alternate DTB. + * If we detect this condition, we need to move the MIPS exception + * vectors up to an area that we own. + * + * This is distinct from the OTHER special case mentioned in + * smp-bmips.c (boot on TP1, but enable SMP, then TP0 becomes our + * logical CPU#1). For the Viper TP1 case, SMP is off limits. + * + * Also note that many BMIPS435x CPUs do not have a + * BMIPS_RELO_VECTOR_CONTROL_1 register, so it isn't safe to just + * write VMLINUX_LOAD_ADDRESS into that register on every SoC. + */ + board_ebase_setup = &kbase_setup; + bmips_smp_enabled = 0; +} + +static void bcm63xx_fixup_cpu1(void) +{ + /* + * The bootloader has set up the CPU1 reset vector at + * 0xa000_0200. + * This conflicts with the special interrupt vector (IV). + * The bootloader has also set up CPU1 to respond to the wrong + * IPI interrupt. + * Here we will start up CPU1 in the background and ask it to + * reconfigure itself then go back to sleep. + */ + memcpy((void *)0xa0000200, &bmips_smp_movevec, 0x20); + __sync(); + set_c0_cause(C_SW0); + cpumask_set_cpu(1, &bmips_booted_mask); +} + +static void bcm6328_quirks(void) +{ + /* Check CPU1 status in OTP (it is usually disabled) */ + if (__raw_readl(REG_BCM6328_OTP) & BCM6328_TP1_DISABLED) + bmips_smp_enabled = 0; + else + bcm63xx_fixup_cpu1(); +} + +static void bcm6358_quirks(void) +{ + /* + * BCM3368/BCM6358 need special handling for their shared TLB, so + * disable SMP for now + */ + bmips_smp_enabled = 0; + + /* + * RAC flush causes kernel panics on BCM6358 when booting from TP1 + * because the bootloader is not initializing it properly. + */ + bmips_rac_flush_disable = !!(read_c0_brcm_cmt_local() & (1 << 31)) || + !!bmips_cbr_addr; +} + +static void bcm6368_quirks(void) +{ + bcm63xx_fixup_cpu1(); +} + +static const struct bmips_quirk bmips_quirk_list[] = { + { "brcm,bcm3368", &bcm6358_quirks }, + { "brcm,bcm3384-viper", &bcm3384_viper_quirks }, + { "brcm,bcm33843-viper", &bcm3384_viper_quirks }, + { "brcm,bcm6328", &bcm6328_quirks }, + { "brcm,bcm6358", &bcm6358_quirks }, + { "brcm,bcm6362", &bcm6368_quirks }, + { "brcm,bcm6368", &bcm6368_quirks }, + { "brcm,bcm63168", &bcm6368_quirks }, + { "brcm,bcm63268", &bcm6368_quirks }, + { }, +}; + +static void __init bmips_init_cfe(void) +{ + cfe_seal = fw_arg3; + + if (cfe_seal != CFE_EPTSEAL) + return; + + cfe_init(fw_arg0, fw_arg2); +} + +void __init prom_init(void) +{ + /* Cache CBR addr before CPU/DMA setup */ + bmips_cbr_addr = BMIPS_GET_CBR(); + bmips_init_cfe(); + bmips_cpu_setup(); + register_bmips_smp_ops(); +} + +const char *get_system_type(void) +{ + return "Generic BMIPS kernel"; +} + +void __init plat_time_init(void) +{ + struct device_node *np; + u32 freq; + + np = of_find_node_by_name(NULL, "cpus"); + if (!np) + panic("missing 'cpus' DT node"); + if (of_property_read_u32(np, "mips-hpt-frequency", &freq) < 0) + panic("missing 'mips-hpt-frequency' property"); + of_node_put(np); + + mips_hpt_frequency = freq; +} + +void __init plat_mem_setup(void) +{ + void *dtb; + const struct bmips_quirk *q; + + set_io_port_base(0); + ioport_resource.start = 0; + ioport_resource.end = ~0; + + /* + * intended to somewhat resemble ARM; see + * Documentation/arch/arm/booting.rst + */ + if (fw_arg0 == 0 && fw_arg1 == 0xffffffff) + dtb = phys_to_virt(fw_arg2); + else + dtb = get_fdt(); + + if (!dtb) + cfe_die("no dtb found"); + + __dt_setup_arch(dtb); + + for (q = bmips_quirk_list; q->quirk_fn; q++) { + if (of_flat_dt_is_compatible(of_get_flat_dt_root(), + q->compatible)) { + q->quirk_fn(); + } + } +} + +void __init device_tree_init(void) +{ + struct device_node *np; + u32 addr; + + unflatten_and_copy_device_tree(); + + /* Disable SMP boot unless both CPUs are listed in DT and !disabled */ + np = of_find_node_by_name(NULL, "cpus"); + if (!np) + return; + + if (of_get_available_child_count(np) <= 1) + bmips_smp_enabled = 0; + + /* Check if DT provide a CBR address */ + if (of_property_read_u32(np, "brcm,bmips-cbr-reg", &addr)) + goto exit; + + /* Make sure CBR address is outside DRAM window */ + if (addr >= (u32)memblock_start_of_DRAM() && + addr < (u32)memblock_end_of_DRAM()) { + WARN(1, "DT CBR %x inside DRAM window. Ignoring DT CBR.\n", + addr); + goto exit; + } + + bmips_cbr_addr = (void __iomem *)addr; + /* Since CBR is provided by DT, enable RAC flush */ + bmips_rac_flush_disable = false; + +exit: + of_node_put(np); +} + +static int __init plat_dev_init(void) +{ + of_clk_init(NULL); + return 0; +} + +arch_initcall(plat_dev_init); -- cgit v1.3.1