From f4cdf7ca9a1fdcca413157df19753f388a5a224e Mon Sep 17 00:00:00 2001 From: Linus Torvalds Date: Wed, 19 Aug 2026 10:09:22 -0700 Subject: Merge tag 'media/v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media Pull media updates from Mauro Carvalho Chehab: - v4l2-core: added ISP statistics support and per-block validation - v4l2-core: Allow unknown HDR10 white point and luminance - New camera sensors: Sony IMX678 and IMX471m, Himax HM1092 IR sensor - New codec: Milos: VPU v2.0 codec support - isp driver: gained support for Dreamchip RPPX1 ISP framework - vsp1 driver: gained support for RZ/T2H and RZ/N2H - Novalake driver: gained CVS support for new NVL hardware - dvb-core: fix feed leak on failed DMX_ADD_PID - several driver fixes, cleanups and minor improvements * tag 'media/v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media: (308 commits) media: ipu-bridge: check all DMI entries when overriding sensor rotation media: v4l2-async: avoid deleting unlinked ASC entry on link error media: rzg2l-cru: Align bytesperline to hardware DMA stride requirement media: intel/ipu6: fix async notifier cleanup leak on parse error media: staging/ipu7: fix async notifier UAF on probe error path media: amd: isp4: fix self-deadlock in isp4sd_pwron_and_init() error path media: amd: isp4: release partial allocations in isp4if_alloc_fw_gpumem() media: rcar-isp: Fix VSPX reference leaks media: rcar-isp: Release ISPCORE resources media: i2c: imx415: Release runtime PM reference on VBLANK error media: i2c: imx415: Return test pattern write errors media: renesas: vsp1: Declare index variables in for loop statement media: renesas: vsp1: Make reset control optional to support platforms without a reset line media: dt-bindings: media: renesas,vsp1: Document RZ/T2H and RZ/N2H SoCs media: dt-bindings: media: renesas,fcp: Document RZ/T2H and RZ/N2H SoCs media: nxp: imx8-isi: Add additional 32-bit RGB format support media: nxp: imx8-isi: Add 16-bit raw Bayer format support media: nxp: imx8-isi: Implement per-stream reference counting for multiplexed streams media: nxp: imx8-isi: Use BIT_ULL() for 64-bit stream masks media: nxp: imx8-isi: Correct color map between V4L2 and ISI ... --- Documentation/driver-api/spi.rst | 53 ++++++++++++++++++++++++++++++++++++++++ 1 file changed, 53 insertions(+) create mode 100644 Documentation/driver-api/spi.rst (limited to 'Documentation/driver-api/spi.rst') diff --git a/Documentation/driver-api/spi.rst b/Documentation/driver-api/spi.rst new file mode 100644 index 000000000..74eca6735 --- /dev/null +++ b/Documentation/driver-api/spi.rst @@ -0,0 +1,53 @@ +Serial Peripheral Interface (SPI) +================================= + +SPI is the "Serial Peripheral Interface", widely used with embedded +systems because it is a simple and efficient interface: basically a +multiplexed shift register. Its three signal wires hold a clock (SCK, +often in the range of 1-20 MHz), a "Master Out, Slave In" (MOSI) data +line, and a "Master In, Slave Out" (MISO) data line. SPI is a full +duplex protocol; for each bit shifted out the MOSI line (one per clock) +another is shifted in on the MISO line. Those bits are assembled into +words of various sizes on the way to and from system memory. An +additional chipselect line is usually active-low (nCS); four signals are +normally used for each peripheral, plus sometimes an interrupt. + +The SPI bus facilities listed here provide a generalized interface to +declare SPI buses and devices, manage them according to the standard +Linux driver model, and perform input/output operations. At this time, +only "master" side interfaces are supported, where Linux talks to SPI +peripherals and does not implement such a peripheral itself. (Interfaces +to support implementing SPI slaves would necessarily look different.) + +The programming interface is structured around two kinds of driver, and +two kinds of device. A "Controller Driver" abstracts the controller +hardware, which may be as simple as a set of GPIO pins or as complex as +a pair of FIFOs connected to dual DMA engines on the other side of the +SPI shift register (maximizing throughput). Such drivers bridge between +whatever bus they sit on (often the platform bus) and SPI, and expose +the SPI side of their device as a :c:type:`struct spi_controller +`. SPI devices are children of that master, +represented as a :c:type:`struct spi_device ` and +manufactured from :c:type:`struct spi_board_info +` descriptors which are usually provided by +board-specific initialization code. A :c:type:`struct spi_driver +` is called a "Protocol Driver", and is bound to a +spi_device using normal driver model calls. + +The I/O model is a set of queued messages. Protocol drivers submit one +or more :c:type:`struct spi_message ` objects, +which are processed and completed asynchronously. (There are synchronous +wrappers, however.) Messages are built from one or more +:c:type:`struct spi_transfer ` objects, each of +which wraps a full duplex SPI transfer. A variety of protocol tweaking +options are needed, because different chips adopt very different +policies for how they use the bits transferred with SPI. + +.. kernel-doc:: include/linux/spi/spi.h + :internal: + +.. kernel-doc:: drivers/spi/spi.c + :functions: spi_register_board_info + +.. kernel-doc:: drivers/spi/spi.c + :export: -- cgit v1.3.1