From cf9610f9116d55c5a66ef9f1faecacabd93a9322 Mon Sep 17 00:00:00 2001 From: Linus Torvalds Date: Mon, 24 Aug 2026 08:46:03 -0700 Subject: Merge tag 'pinctrl-v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl Pull pin control updates from Linus Walleij: "Core changes: - Use the non-blocking mux_state_try_select() in the generic MUX pin control back-end - Free pin maps on pinctrl_generic_to_map() failure in the core helpers New hardware pin control: - Qualcomm Maili TLMM SoC, PMG1110 PMIC, and Eliza LPASS LPI TLMM SoC (this is for the low power audio, LPASS = Low Power Audio SubSystem portions) - Upboard support on top of the Intel pin controller - Apple T6030 and T6031 support (just compatible strings) - Samsung Exynos 8855 SoC - Mediatek MT6858 SoC - Rockchip RK3308B and RV1106 SoCs - Airoha EN7523 and AN7563 SoCs Improvements: - Qualcomm TLMM GPIOs are unconditionally marked as wakeup capable - Qualcomm improvements on top of the Qualcomm PDC (power domain controller) irqchip improvements from tglx:s tree - Qualcomm IPQ806x and IPQ9650 non-urgent pin grop fixups - The NPCM8xx driver has been put into shape fixing many pin and group definitions - Some non-urgent Tegra 264 pin assignments are fixed up - Some non-urgent fixups to Airoha AN7581 and AN7583 registers and pin assignments, missing features etc" * tag 'pinctrl-v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (130 commits) dt-bindings: pinctrl: Convert TI DA850 pupd to DT schema pinctrl: meson: sync some modify from A4 pinctrl: meson: a4: Add input enable pin configuration pinctrl: realtek: rtd1625: remove unused group name spdif_sel pinctrl: realtek: rtd1625: fix base_bit for VE4 GPIO 13 dt-bindings: pinctrl: microchip,pic32mzda-pinctrl: Convert to DT schema Revert "Merge branch 'ib-rsk7204' into devel" pinctrl: rockchip: Add RV1106 pinctrl support dt-bindings: pinctrl: rockchip: Add RV1106 compatible pinctrl: rockchip: Decode drive strength in the get function pinctrl: fix PINCTRL_GENERIC_MUX not always being selectable pinctrl: airoha: add support of an7563 SoC dt-bindings: pinctrl: airoha: add support of an7563 pin controller pinctrl: airoha: try to find chip scu node by phandle first pinctrl: airoha: add support of en7523 SoC dt-bindings: pinctrl: airoha: add support of en7523 pin controller pinctrl: airoha: an7583: add support for olt pinmux pinctrl: airoha: an7583: add support for pon_alt pinmux pinctrl: airoha: an7583: add support for npu_uart pinmux dt-bindings: pinctrl: airoha: an7583: add missed features ... --- Documentation/driver-api/i2c.rst | 48 ++++++++++++++++++++++++++++++++++++++++ 1 file changed, 48 insertions(+) create mode 100644 Documentation/driver-api/i2c.rst (limited to 'Documentation/driver-api/i2c.rst') diff --git a/Documentation/driver-api/i2c.rst b/Documentation/driver-api/i2c.rst new file mode 100644 index 000000000..7582c079d --- /dev/null +++ b/Documentation/driver-api/i2c.rst @@ -0,0 +1,48 @@ +I\ :sup:`2`\ C and SMBus Subsystem +================================== + +I\ :sup:`2`\ C (or without fancy typography, "I2C") is an acronym for +the "Inter-IC" bus, a simple bus protocol which is widely used where low +data rate communications suffice. Since it's also a licensed trademark, +some vendors use another name (such as "Two-Wire Interface", TWI) for +the same bus. I2C only needs two signals (SCL for clock, SDA for data), +conserving board real estate and minimizing signal quality issues. Most +I2C devices use seven bit addresses, and bus speeds of up to 400 kHz; +there's a high speed extension (3.4 MHz) that's not yet found wide use. +I2C is a multi-master bus; open drain signaling is used to arbitrate +between masters, as well as to handshake and to synchronize clocks from +slower clients. + +The Linux I2C programming interfaces support the master side of bus +interactions and the slave side. The programming interface is +structured around two kinds of driver, and two kinds of device. An I2C +"Adapter Driver" abstracts the controller hardware; it binds to a +physical device (perhaps a PCI device or platform_device) and exposes a +:c:type:`struct i2c_adapter ` representing each +I2C bus segment it manages. On each I2C bus segment will be I2C devices +represented by a :c:type:`struct i2c_client `. +Those devices will be bound to a :c:type:`struct i2c_driver +`, which should follow the standard Linux driver model. There +are functions to perform various I2C protocol operations; at this writing +all such functions are usable only from task context. + +The System Management Bus (SMBus) is a sibling protocol. Most SMBus +systems are also I2C conformant. The electrical constraints are tighter +for SMBus, and it standardizes particular protocol messages and idioms. +Controllers that support I2C can also support most SMBus operations, but +SMBus controllers don't support all the protocol options that an I2C +controller will. There are functions to perform various SMBus protocol +operations, either using I2C primitives or by issuing SMBus commands to +i2c_adapter devices which don't support those I2C operations. + +.. kernel-doc:: include/linux/i2c.h + :internal: + +.. kernel-doc:: drivers/i2c/i2c-boardinfo.c + :functions: i2c_register_board_info + +.. kernel-doc:: drivers/i2c/i2c-core-base.c + :export: + +.. kernel-doc:: drivers/i2c/i2c-core-smbus.c + :export: -- cgit v1.3.1