From e24328974a88aa8541e94e8bb8dfa2ade1b3c45d Mon Sep 17 00:00:00 2001 From: Donggeun Yoo Date: Wed, 2 Sep 2026 00:21:26 +0900 Subject: iio: proximity: vl53l0x-i2c: claim direct mode for raw reads vl53l0x_read_raw() starts a single-shot ranging measurement and reads back the result. Once the triggered buffer is enabled the sensor runs in continuous mode and its data-ready interrupt is routed to the trigger, so a concurrent in_distance_raw read disturbs the streaming setup and never gets its completion, returning -ETIMEDOUT. The original submission claimed direct mode here, but it was dropped during review because the driver had no buffer support at the time [1]. Continuous (buffered) mode was later added without restoring the claim [2], reintroducing the conflict. Reject direct reads while buffered capture is active by claiming direct mode around the measurement, as the vl53l1x sibling already does. Fixes: 762186c6e7b1 ("iio: proximity: vl53l0x-i2c: Added continuous mode support") Link: https://lore.kernel.org/linux-iio/20180911160300.GA9212@himanshu-Vostro-3559/ [1] Link: https://lore.kernel.org/linux-iio/20240909101508.263085-3-abhashkumarjha123@gmail.com/ [2] Signed-off-by: Donggeun Yoo Cc: stable@vger.kernel.org Signed-off-by: Jonathan Cameron --- Documentation/driver-api/firmware/introduction.rst | 27 ++++++++++++++++++++++ 1 file changed, 27 insertions(+) create mode 100644 Documentation/driver-api/firmware/introduction.rst (limited to 'Documentation/driver-api/firmware/introduction.rst') diff --git a/Documentation/driver-api/firmware/introduction.rst b/Documentation/driver-api/firmware/introduction.rst new file mode 100644 index 000000000..211cb44eb --- /dev/null +++ b/Documentation/driver-api/firmware/introduction.rst @@ -0,0 +1,27 @@ +============ +Introduction +============ + +The firmware API enables kernel code to request files required +for functionality from userspace, the uses vary: + +* Microcode for CPU errata +* Device driver firmware, required to be loaded onto device + microcontrollers +* Device driver information data (calibration data, EEPROM overrides), + some of which can be completely optional. + +Types of firmware requests +========================== + +There are two types of calls: + +* Synchronous +* Asynchronous + +Which one you use vary depending on your requirements, the rule of thumb +however is you should strive to use the asynchronous APIs unless you also +are already using asynchronous initialization mechanisms which will not +stall or delay boot. Even if loading firmware does not take a lot of time +processing firmware might, and this can still delay boot or initialization, +as such mechanisms such as asynchronous probe can help supplement drivers. -- cgit v1.3.1