From e24328974a88aa8541e94e8bb8dfa2ade1b3c45d Mon Sep 17 00:00:00 2001 From: Donggeun Yoo Date: Wed, 2 Sep 2026 00:21:26 +0900 Subject: iio: proximity: vl53l0x-i2c: claim direct mode for raw reads vl53l0x_read_raw() starts a single-shot ranging measurement and reads back the result. Once the triggered buffer is enabled the sensor runs in continuous mode and its data-ready interrupt is routed to the trigger, so a concurrent in_distance_raw read disturbs the streaming setup and never gets its completion, returning -ETIMEDOUT. The original submission claimed direct mode here, but it was dropped during review because the driver had no buffer support at the time [1]. Continuous (buffered) mode was later added without restoring the claim [2], reintroducing the conflict. Reject direct reads while buffered capture is active by claiming direct mode around the measurement, as the vl53l1x sibling already does. Fixes: 762186c6e7b1 ("iio: proximity: vl53l0x-i2c: Added continuous mode support") Link: https://lore.kernel.org/linux-iio/20180911160300.GA9212@himanshu-Vostro-3559/ [1] Link: https://lore.kernel.org/linux-iio/20240909101508.263085-3-abhashkumarjha123@gmail.com/ [2] Signed-off-by: Donggeun Yoo Cc: stable@vger.kernel.org Signed-off-by: Jonathan Cameron --- Documentation/devicetree/changesets.rst | 37 +++++++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+) create mode 100644 Documentation/devicetree/changesets.rst (limited to 'Documentation/devicetree/changesets.rst') diff --git a/Documentation/devicetree/changesets.rst b/Documentation/devicetree/changesets.rst new file mode 100644 index 000000000..2091468d4 --- /dev/null +++ b/Documentation/devicetree/changesets.rst @@ -0,0 +1,37 @@ +.. SPDX-License-Identifier: GPL-2.0 + +===================== +Devicetree Changesets +===================== + +A Devicetree changeset is a method which allows one to apply changes +in the live tree in such a way that either the full set of changes +will be applied, or none of them will be. If an error occurs partway +through applying the changeset, then the tree will be rolled back to the +previous state. A changeset can also be removed after it has been +applied. + +When a changeset is applied, all of the changes get applied to the tree +at once before emitting OF_RECONFIG notifiers. This is so that the +receiver sees a complete and consistent state of the tree when it +receives the notifier. + +The sequence of a changeset is as follows. + +1. of_changeset_init() - initializes a changeset + +2. A number of DT tree change calls, of_changeset_attach_node(), + of_changeset_detach_node(), of_changeset_add_property(), + of_changeset_remove_property, of_changeset_update_property() to prepare + a set of changes. No changes to the active tree are made at this point. + All the change operations are recorded in the of_changeset 'entries' + list. + +3. of_changeset_apply() - Apply the changes to the tree. Either the + entire changeset will get applied, or if there is an error the tree will + be restored to the previous state. The core ensures proper serialization + through locking. An unlocked version __of_changeset_apply is available, + if needed. + +If a successfully applied changeset needs to be removed, it can be done +with of_changeset_revert(). -- cgit v1.3.1