From 106b4a2a78b2a2f14885604891957b84bba502db Mon Sep 17 00:00:00 2001 From: Adrian Betschart Date: Fri, 11 Sep 2026 17:13:14 +0200 Subject: drm/amd/display: Try RGB before YCbCr 4:4:4 in stream validation amdgpu_dm_create_validate_stream_for_sink() walks encoding_order[] and uses the first encoding that validates. YCbCr 4:4:4 is listed before RGB, so an HDMI sink that advertises 4:4:4 gets YCbCr 4:4:4 whenever the "color format" property is left at AUTO, even though RGB fits the same link. That contradicts the documented AUTO behaviour for HDMI in enum drm_connector_color_format (RGB, falling back to YCbCr 4:2:0 only when the bandwidth is not available or the mode is 4:2:0-only), which the amdgpu implementation of the property also describes. It also leaves the "Broadcast RGB" property without effect on such sinks, since the quantization range it selects only applies to RGB output. Try RGB first. The mask still holds every encoding the sink supports, so a mode that cannot carry RGB falls back exactly as before. For reference, v7.2 picked RGB here unless YCbCr 4:4:4 was forced through debugfs, while earlier kernels picked YCbCr 4:4:4 for any HDMI sink that advertised it. Fixes: 0b0ff65d3ca1 ("drm/amd/display: Refactor stream validation") Suggested-by: Adolfo Rodrigues Assisted-by: Claude Code:claude-fable-5-1 Signed-off-by: Adrian Betschart Reviewed-by: Fangzhi Zuo Tested-by: Adolfo Rodrigues Tested-by: Daniel Wheeler Signed-off-by: Alex Deucher (cherry picked from commit 7de432bc753133764dc40d37f9388da56de251e7) --- .../devicetree/bindings/regmap/regmap.txt | 29 ++++++++++++++++++++++ 1 file changed, 29 insertions(+) create mode 100644 Documentation/devicetree/bindings/regmap/regmap.txt (limited to 'Documentation/devicetree/bindings/regmap') diff --git a/Documentation/devicetree/bindings/regmap/regmap.txt b/Documentation/devicetree/bindings/regmap/regmap.txt new file mode 100644 index 000000000..873096be0 --- /dev/null +++ b/Documentation/devicetree/bindings/regmap/regmap.txt @@ -0,0 +1,29 @@ +Devicetree binding for regmap + +Optional properties: + + little-endian, + big-endian, + native-endian: See common-properties.txt for a definition + +Note: +Regmap defaults to little-endian register access on MMIO based +devices, this is by far the most common setting. On CPU +architectures that typically run big-endian operating systems +(e.g. PowerPC), registers can be defined as big-endian and must +be marked that way in the devicetree. + +On SoCs that can be operated in both big-endian and little-endian +modes, with a single hardware switch controlling both the endianness +of the CPU and a byteswap for MMIO registers (e.g. many Broadcom MIPS +chips), "native-endian" is used to allow using the same device tree +blob in both cases. + +Examples: +Scenario 1 : a register set in big-endian mode. +dev: dev@40031000 { + compatible = "syscon"; + reg = <0x40031000 0x1000>; + big-endian; + ... +}; -- cgit v1.3.1