From 78004e9a87f240df03e2f73120d291763c32e0a7 Mon Sep 17 00:00:00 2001 From: Ali Ahmet Memis Date: Fri, 21 Aug 2026 01:45:27 +0000 Subject: openrisc: fix arbitrary kernel memory access via or1k_atomic syscall sys_or1k_atomic() (syscall 244 in the "or1k" ABI) takes two user pointers, v1 and v2, and swaps the words they point to in hand-written assembly. l.lwz r29,0(r4) l.lwz r27,0(r5) l.sw 0(r4),r27 l.sw 0(r5),r29 The pointers are not checked with access_ok(). The four memory accesses also have no exception table entries. A caller passes a kernel address as either pointer, and the syscall reads from and writes to it directly. This gives an unprivileged process a kernel read/write primitive. It overwrites kernel data such as the sys_call_table, gaining code execution in kernel context. Check both pointers before entering the critical section. Add fixups for the four memory accesses so faults on valid but unmapped user addresses return -EFAULT. [shorne@gmail.com: fix comment style] Fixes: 9d02a4283e9c ("OpenRISC: Boot code") Cc: stable@vger.kernel.org Signed-off-by: Ali Ahmet Memis Signed-off-by: Stafford Horne --- Documentation/admin-guide/edid.rst | 27 +++++++++++++++++++++++++++ 1 file changed, 27 insertions(+) create mode 100644 Documentation/admin-guide/edid.rst (limited to 'Documentation/admin-guide/edid.rst') diff --git a/Documentation/admin-guide/edid.rst b/Documentation/admin-guide/edid.rst new file mode 100644 index 000000000..1a9b965aa --- /dev/null +++ b/Documentation/admin-guide/edid.rst @@ -0,0 +1,27 @@ +.. SPDX-License-Identifier: GPL-2.0 + +==== +EDID +==== + +In the good old days when graphics parameters were configured explicitly +in a file called xorg.conf, even broken hardware could be managed. + +Today, with the advent of Kernel Mode Setting, a graphics board is +either correctly working because all components follow the standards - +or the computer is unusable, because the screen remains dark after +booting or it displays the wrong area. Cases when this happens are: + +- The graphics board does not recognize the monitor. +- The graphics board is unable to detect any EDID data. +- The graphics board incorrectly forwards EDID data to the driver. +- The monitor sends no or bogus EDID data. +- A KVM sends its own EDID data instead of querying the connected monitor. + +Adding the kernel parameter "nomodeset" helps in most cases, but causes +restrictions later on. + +As a remedy for such situations, the kernel configuration item +CONFIG_DRM_LOAD_EDID_FIRMWARE was introduced. It allows to provide an +individually prepared or corrected EDID data set in the /lib/firmware +directory from where it is loaded via the firmware interface. -- cgit v1.3.1