From 78004e9a87f240df03e2f73120d291763c32e0a7 Mon Sep 17 00:00:00 2001 From: Ali Ahmet Memis Date: Fri, 21 Aug 2026 01:45:27 +0000 Subject: openrisc: fix arbitrary kernel memory access via or1k_atomic syscall sys_or1k_atomic() (syscall 244 in the "or1k" ABI) takes two user pointers, v1 and v2, and swaps the words they point to in hand-written assembly. l.lwz r29,0(r4) l.lwz r27,0(r5) l.sw 0(r4),r27 l.sw 0(r5),r29 The pointers are not checked with access_ok(). The four memory accesses also have no exception table entries. A caller passes a kernel address as either pointer, and the syscall reads from and writes to it directly. This gives an unprivileged process a kernel read/write primitive. It overwrites kernel data such as the sys_call_table, gaining code execution in kernel context. Check both pointers before entering the critical section. Add fixups for the four memory accesses so faults on valid but unmapped user addresses return -EFAULT. [shorne@gmail.com: fix comment style] Fixes: 9d02a4283e9c ("OpenRISC: Boot code") Cc: stable@vger.kernel.org Signed-off-by: Ali Ahmet Memis Signed-off-by: Stafford Horne --- Documentation/admin-guide/braille-console.rst | 38 +++++++++++++++++++++++++++ 1 file changed, 38 insertions(+) create mode 100644 Documentation/admin-guide/braille-console.rst (limited to 'Documentation/admin-guide/braille-console.rst') diff --git a/Documentation/admin-guide/braille-console.rst b/Documentation/admin-guide/braille-console.rst new file mode 100644 index 000000000..153472e93 --- /dev/null +++ b/Documentation/admin-guide/braille-console.rst @@ -0,0 +1,38 @@ +Linux Braille Console +===================== + +To get early boot messages on a braille device (before userspace screen +readers can start), you first need to compile the support for the usual serial +console (see :ref:`Documentation/admin-guide/serial-console.rst `), and +for braille device +(in :menuselection:`Device Drivers --> Accessibility support --> Console on braille device`). + +Then you need to specify a ``console=brl``, option on the kernel command line, the +format is:: + + console=brl,serial_options... + +where ``serial_options...`` are the same as described in +:ref:`Documentation/admin-guide/serial-console.rst `. + +So for instance you can use ``console=brl,ttyS0`` if the braille device is connected to the first serial port, and ``console=brl,ttyS0,115200`` to +override the baud rate to 115200, etc. + +By default, the braille device will just show the last kernel message (console +mode). To review previous messages, press the Insert key to switch to the VT +review mode. In review mode, the arrow keys permit to browse in the VT content, +`PAGE-UP`/`PAGE-DOWN` keys go at the top/bottom of the screen, and +the `HOME` key goes back +to the cursor, hence providing very basic screen reviewing facility. + +Sound feedback can be obtained by adding the ``braille_console.sound=1`` kernel +parameter. + +For simplicity, only one braille console can be enabled, other uses of +``console=brl,...`` will be discarded. Also note that it does not interfere with +the console selection mechanism described in +:ref:`Documentation/admin-guide/serial-console.rst `. + +For now, only the VisioBraille device is supported. + +Samuel Thibault -- cgit v1.3.1