From 506ada89629ec7059b96ecfb0dc7d33ece0103ca Mon Sep 17 00:00:00 2001 From: Eduard Zingerman Date: Fri, 4 Sep 2026 17:05:56 -0700 Subject: bpf: mark a NULL kfunc argument precise check_kfunc_arg() allows bpf_register_is_null() for nullable arguments w/o marking the underlying scalar register precise. Hence a checkpoint created on such a path would prune against arbitrary scalar value. Fixes: 3bda08b63670 ("bpf: Allow NULL buffers in bpf_dynptr_slice(_rw)") Signed-off-by: Eduard Zingerman Link: https://lore.kernel.org/r/20260904-register-is-null-precise-fixes-v1-5-0f5a360ff15d@gmail.com Signed-off-by: Alexei Starovoitov --- Documentation/admin-guide/braille-console.rst | 38 +++++++++++++++++++++++++++ 1 file changed, 38 insertions(+) create mode 100644 Documentation/admin-guide/braille-console.rst (limited to 'Documentation/admin-guide/braille-console.rst') diff --git a/Documentation/admin-guide/braille-console.rst b/Documentation/admin-guide/braille-console.rst new file mode 100644 index 000000000..153472e93 --- /dev/null +++ b/Documentation/admin-guide/braille-console.rst @@ -0,0 +1,38 @@ +Linux Braille Console +===================== + +To get early boot messages on a braille device (before userspace screen +readers can start), you first need to compile the support for the usual serial +console (see :ref:`Documentation/admin-guide/serial-console.rst `), and +for braille device +(in :menuselection:`Device Drivers --> Accessibility support --> Console on braille device`). + +Then you need to specify a ``console=brl``, option on the kernel command line, the +format is:: + + console=brl,serial_options... + +where ``serial_options...`` are the same as described in +:ref:`Documentation/admin-guide/serial-console.rst `. + +So for instance you can use ``console=brl,ttyS0`` if the braille device is connected to the first serial port, and ``console=brl,ttyS0,115200`` to +override the baud rate to 115200, etc. + +By default, the braille device will just show the last kernel message (console +mode). To review previous messages, press the Insert key to switch to the VT +review mode. In review mode, the arrow keys permit to browse in the VT content, +`PAGE-UP`/`PAGE-DOWN` keys go at the top/bottom of the screen, and +the `HOME` key goes back +to the cursor, hence providing very basic screen reviewing facility. + +Sound feedback can be obtained by adding the ``braille_console.sound=1`` kernel +parameter. + +For simplicity, only one braille console can be enabled, other uses of +``console=brl,...`` will be discarded. Also note that it does not interfere with +the console selection mechanism described in +:ref:`Documentation/admin-guide/serial-console.rst `. + +For now, only the VisioBraille device is supported. + +Samuel Thibault -- cgit v1.3.1