From 2bd30b8dc75b823dd7bbef9d7bc68e1fd7ecee5c Mon Sep 17 00:00:00 2001 From: Sang-Heon Jeon Date: Mon, 24 Aug 2026 01:18:14 +0900 Subject: coccinelle: alloc_cast: drop removed allocators - pci_alloc_consistent() and pci_zalloc_consistent() were removed by commit 7968778914e5 ("PCI: Remove the deprecated "pci-dma-compat.h" API") - kmem_alloc() was removed by commit f078d4ea8276 ("xfs: convert kmem_alloc() to kmalloc()") - kmem_zalloc() was removed by commit 10634530f7ba ("xfs: convert kmem_zalloc() to kzalloc()") - kmem_zone_alloc() and kmem_zone_zalloc() were removed by commit bae633a4a283 ("xfs: remove xfs_zone_{alloc,zalloc} helpers") So drop them from the rules. No functional change. Signed-off-by: Sang-Heon Jeon Signed-off-by: Julia Lawall --- Documentation/ABI/testing/sysfs-driver-hid-picolcd | 43 ++++++++++++++++++++++ 1 file changed, 43 insertions(+) create mode 100644 Documentation/ABI/testing/sysfs-driver-hid-picolcd (limited to 'Documentation/ABI/testing/sysfs-driver-hid-picolcd') diff --git a/Documentation/ABI/testing/sysfs-driver-hid-picolcd b/Documentation/ABI/testing/sysfs-driver-hid-picolcd new file mode 100644 index 000000000..98fd81ad7 --- /dev/null +++ b/Documentation/ABI/testing/sysfs-driver-hid-picolcd @@ -0,0 +1,43 @@ +What: /sys/bus/usb/devices/-:./::./operation_mode +Date: March 2010 +Contact: Bruno Prémont +Description: Make it possible to switch the PicoLCD device between LCD + (firmware) and bootloader (flasher) operation modes. + + Reading: returns list of available modes, the active mode being + enclosed in brackets ('[' and ']') + + Writing: causes operation mode switch. Permitted values are + the non-active mode names listed when read. + + Note: when switching mode the current PicoLCD HID device gets + disconnected and reconnects after above delay (see attribute + operation_mode_delay for its value). + + +What: /sys/bus/usb/devices/-:./::./operation_mode_delay +Date: April 2010 +Contact: Bruno Prémont +Description: Delay PicoLCD waits before restarting in new mode when + operation_mode has changed. + + Reading/Writing: It is expressed in ms and permitted range is + 0..30000ms. + + +What: /sys/bus/usb/devices/-:./::./fb_update_rate +Date: March 2010 +Contact: Bruno Prémont +Description: Make it possible to adjust defio refresh rate. + + Reading: returns list of available refresh rates (expressed in Hz), + the active refresh rate being enclosed in brackets ('[' and ']') + + Writing: accepts new refresh rate expressed in integer Hz + within permitted rates. + + Note: As device can barely do 2 complete refreshes a second + it only makes sense to adjust this value if only one or two + tiles get changed and it's not appropriate to expect the application + to flush its tiny changes explicitly at higher than default rate. + -- cgit v1.3.1